Gypsum tiles have to be laid properly, as not only the aesthetic look of cosmetic facing, but also the service quality of the
substance will be dependent on the technologies of job. The product is universal, and it may be connected to concrete, plaster,
brick or gypsum board sheets, provided the top layer of the base is and has no defects.
If the flaws of the foundation are important, it should be thoroughly treated with primer, and then a cement mortar is made, which
satisfies all of the cracks. Subsequently the surface should be primed and dried. Primer therapy is necessary to improve the bond
between the tile and the walls. In cases like this, its makeup should decide on a particular, containing elements which block the
look of fungus and mould.
In the modern interior of the rooms most often used gypsum tiles, imitating natural brick or stone. To execute decorative
finishing your self, it is essential first of all to pick a strategy of tile positioning and prepare a solution. It’s crucial to
pay attention to the opposite side of this material. If its surface has an embossed surface, then the glue ought to be put with an
even trowel, and if it is even, then with a notched one.
The tech of this work is as follows:
* A thin coating of adhesive is put on the pre-prepared wall. It’s distributed over the foundation so it is likely to put 4-5
tiles. Decorative cladding can be put both on plasterboard, and on putty.
* Cover the rear side of the tiles with adhesive.
* Plaster elements are pressed against the wall and their place is corrected. To align the seams, it is suggested to use
spacers.
* Finishing is performed in rows, all which ought to be changed by half a tile. Facing is carried out into the corners of the
space, then immediately remove any residual mortar at the joints.
Drying the walls requires no longer than a day also takes a constant humidity and temperature inside the room. The last point in
the placing of gypsum tiles is their own decor. To get this done, the joints between these components are filled with a special
solution, the color of which matches the brick.
Cosmetic fake of brickwork on the walls will be completed in the following ways:
* Cutting the plastered surface of the stitches of masonry with a bolt cutter with your hands;
* laying of tiles under the brick:
* imitating the format and colour of the side surface of a single brick;
* Imitating a fragment of brickwork of several bricks.
The best method to decorate”beneath the brick” is the one which allows you to make a functional coating with the maximum
appearance of its similarity to organic masonry. All three ways to conduct this sort of finishing functions meet the demands,
however, the cutting of joints with a bolt is more labor-intensive and the creation of considerable amounts of dust, so let us
consider more prevalent ways.
The old finish is removed from the walls, and also the surface, if necessary, is leveled to eliminate the requirement to paste
plaster onto a thick layer of adhesive.
Combining such cladding with different types of interior finishes could be both orderly and done with no apparent consistency,
chaotically, together with fake of signs of aging.
With the help of cosmetic gypsum tiles it is possible to mimic a large number of textures.
A lot of textures can be imitated with the support of decorative gypsum tiles.
The wall on which it is to be set up should have the following attributes:
* Hardness and intensity of the surface;
* The absence of uneven locations and sharp gaps;
* not any deformations.
Cosmetic tiles in the interior of the kitchen
Walls are created from a variety of materials, let’s break down the principles of installation.
When working with concrete, there’ll be no big problems. It is just essential to take into consideration the porosity of the
material. Concrete, that has almost no pronounced pores, should be treated with a good primer.
Mounting gypsum tiles on concrete
Before starting work on the setup of gypsum tiles in the walls, then it’s worth checking the strength of the surface. When the
plaster doesn’t drop off the walls and in the identical time holds nicely, you can simply paint it using primer.
Mount the tiles onto the painted concrete shouldn’t. The surface should be scratched, making sure to misfire, then it ought to be
grouted and covered with a layer of plaster.