The whole set for the building of a 4-meter greenhouse 3 sheets of cellular polycarbonate in the shape of rolls of 2.1 m length and a diameter of 60-90 cm. The thickness of this substance is 4 mm.
If you would like, you can raise the amount of the structure to 6 metres or more. gidpostroy.ru To do this, it is enough to attach a two-meter extension. When picking a drawing, then look closely at the space between the arches. This figure should be 65 cm, and which is the most appropriate length for the specified thickness of the substance. The width of the doorways based on the manufacturer’s drawing is 90 cm.
Before building a polycarbonate greenhouse, it’s important to choose a location because of its place. If that is done correctly, it is possible to provide yourself with a crop of fresh veggies for the entire year.
The location for your upcoming greenhouse is marked immediately at the preparation of the garden plot. So as to melt the snow in the positioning of the greenhouse as early as possible, the best point on the website will be a slight elevation. Moreover, in this location won’t need to be worried about high humidity as dirt and atmosphere inside the building.
Assemble a polycarbonate greenhouse on a raised site – intends to take care of the best temperature inside.
If it isn’t feasible to place a greenhouse on an elevated place, you’ll need to pour a layer of fine shattered rock about 20 cm and the same layer of fertile land to make seedbeds.
Before building a greenhouse on your backyard plot, it’s also wise to think about where and how this structure will be set up. To begin with, you must choose a place for it. The greenhouse ought to be located at a metropolitan region at least a couple meters away from houses, barns and other structures.
How to Put in a greenhouse Based on the Faces of the world
Be sure to level the dirt surface – it is best to remove the surface. This will also get rid of weed seeds. And for simplicity of work, remove the dirt in an area that is about a meter wider on each side of the rectangle that you desire.
It’s also worth considering using a foundation. As producers state, today most greenhouses do not need it, particularly if they (greenhouses) are utilized just in the spring and summer time. However, experienced gardeners still recommend earning an elementary basis from a pub. It’s quite simple – it’s sufficient to link with each other using metal screws and corners four parts of wood with a cross-section of 10 * 10 cm. The size of such a base ought to be equal to the base of the future greenhouse.
Simple bar base
You could even make a strip foundation of concrete. He’s more reliable than a bar base, but demands greater fiscal and labor costs. Incidentally, the greenhouse, which will be utilised in winter, with no and do not do without it whatsoever.
Stages of the creation of a strip base: a schematic representation
Many producers counsel to install greenhouse structures without building a base. For this function, they equip the framework with special T-shaped legs, so that the structure was firmly fixed. However, as practice shows, it is still required to build a base: so and the foundation will be more firmly fixed and also the elements of the foundation that are in touch with the soil, will be saved much more in its original state.
The most important thing is to see to the material with special agents to protect the timber from moisture. The material is usually installed on concrete blocks which are dug into the ground. For a six-meter arrangement, they want 10 pieces: four on either side and one at the center of the endings.
Before you perform the greenhouse , you need to choose the perfect location for this. It must be an even site, so the framework was found evenly, without distortions. It needs to be bright and never obscured by buildings or trees.